Matrox Maevex

Back to Product list

Maevex PowerStream Software and Firmware

To take advantage of the latest PowerStream software features, you need the latest Maevex firmware.

Update your software and firmware as follows:

   1. Download and install the PowerStream Software file.
   2. Verify the firmware revision number of all Maevex units using PowerStream and identify units that may require a firmware update.
   3. Download the combined Firmware and Firmware update utility, if required.
   4. Update all units with older firmware to the latest firmware version using the firmware update instructions.
   5. Expect a ~5 minute delay to update all units in parallel (Click the "Update Maevex units in parallel" checkbox in the firmware update utility).

Please note: For new deployments, IP addresses must be assigned to Maevex units. The Maevex PowerStream application must be installed on a system within the Maevex subnet and the network must initially include a DHCP service in order to properly assign IP addresses to the units and then perform a Maevex firmware update. All Maevex units on a given Maevex network require the same firmware & software revisions.

Date Released	PowerStream Software	Firmware & update utility	Release Notes
2013-06-26	PowerStream Setup 1.01.00.017 Windows 8 (64-bit or 32-bit) Windows 7 (64-bit or 32-bit) Windows Server 2012 (64-bit) Windows Server 2008R2 (64-bit)	Firmware Version 1.01.00.017 Please follow the firmware update instructions.	Supported operating systems: Windows 8, Windows 7, Windows Server 2012 & Windows Server 2008. What to expect from your hardware and software - please see release notes.